RHP-BOS-VPC-IF - USB3
Video Power Communication Interface
The Low Profile Boson VPC Interface Module simplifies integration. Two alternate Video & Power connections on the Low Profile Boson VPC Interface Module allows for a variety of installation options.
FLIR Boson GUI Friendly
You can adjust all the parameters available on the FLIR Boson using the FLIR Boson GUI when connected to your PC via the supplied USB cable.
Reverse Polarity Protected
With the intelligent polarity sensing protection, the RHP-BOS-VPC-IF can be powered from the alternate 6-Pin JST ports to USB or a 5-26VDC power source
* Please Note: External Sync is disabled on Boson ≤9Hz Cameras.
The use of external sync on these cameras is not supported because pulses cannot be correlated to a specific output frame because of the way the reduced frame rate video is created. If attempted, the camera will reject commands to begin external sync mode.
|Power Requirements:||5 Volts DC - 25 Volts DC|
|Power Dissipated:||Avg. 0.84W - Max. 2W|
|Dimensions:||21mm x 21mm|
|Video Output:||6pin JST (USB2.0 +
Sync) and 7pin JST (USB3)
|Weight||2.6g without camera|
|Dimensions (L x W x H)||21x21x1.6mm(w/o Connector)
|CONNECTIONS & COMMUNICATIONS|
|Connector||6pin JST (USB2.0 + Sync) and 7pin JST (USB3)|
|Mounting Features||Four M1.6 Holes|
|ELECTRICAL & MECHANICAL|
|Control Channels||USB 3.0 (Video + Control)|
|Video Channels||USB Digital Video|
|Operational Altitude||12km (max altitude of a commercial airliner or airborne platform)|
|Operating Temperature Range||-40°C to 80°C|
|Storage Temperature Range||-50°C to 105°C|
|Input Voltage||5-26VDC - Reverse Polarity Protected|
|Power Dissipation||<0.1W (Camera Not Included) 3.5W Max With Camera, 6W Total Fused|
Interface Assemblies Frequently Asked Questions
The FLIR Boson requires at least one interface board to allow Power and acquire Video from it's high-density connector.
The most popular board in our product list is the Low Profile VPC module. It allows for power input, streaming USB and composite analog video as well as controlling the cameras settings.
A complete list of accessories are available at: https://www.oemcameras.com/boson_accessories.
For video acquisition and control you will need to use the Boson Controller GUI 3.0 available from Teledyne FLIR.
With the RHP Boson interface boards, you may also use the RHP Boson GUI.
If the USB Sensor in the Teledyne FLIR Boson is not triggered (on startup) with the proper voltage for USB-3, it will default to USB-2.
There are three ways to correct this.
- Disconnect the device from the PC and reconnect.
- When powering from a PC, it is best to connect USB-3 after the computer has booted up.
- In some cases, the RHP-BOS-VPC3-IF can be modified to disable the voltage protection.
Please contact support before placing your order for this modification.