FLIR BOSON

FLIR Boson Comparison Matrix

 

Accessories & Interfaces:

The RHP-BOS-RC-IF allows you to control the Boson camera remotely using a 16 Channel S-Bus Signial or up to 5 PWM Signals from your wireless Joystick Remote Control System.


The HD Video output allows a video signal to be transmitted securely through a video transmitter in 720 or 1080p. The analog output can output the composite video signal simultaneously, enabling you to connect to a recording device.


5 to 26VDC In, Dual Composite Video Out - Switchable Sync Input/Output, USB or TTL Communication, Alternate connection ports, Reverse Polarity Protected


5 to 26VDC In, Dual Composite Video Out, Low Profile, Alternate connection ports, USB Communication, Reverse Polarity Protected.


Converts the Boson Camera to Camera Link and provides Sync access.


Two sensors allow a visible image and thermal image to be controlled and transmitted simultaneously. Engineered for drone use, the lightweight RHP-BOS-DS-IF is easy to configure and simple to connect.


The replicator board adapts the Tau 2 interfaces electronically to make them compatible to the FLIR Boson Camera.


USB interface to Boson for power and adjusting cameras parameters using FLIR Boson  GUI.


USB interface to Boson for power and adjusting cameras parameters using FLIR Boson GUI with analog video output via BNC male connector.


Full access to Boson 80-pin interface; includes USB 3, 100/GigE Ethernet, CameraLink, Serial Com, Micro SDCard, I2C, SPI, SDIO and VSYNC/RESET, GPIO


CameraLink and USB interface to Boson video.


Custom tool to change lens focus.


Custom tripod mount with 1/4-20 interface.

Set Descending Direction
View as Grid List

9 Items

per page
Set Descending Direction
View as Grid List

9 Items

per page
celibate-corinthian